• T. Furukawa, T. Inaniwa, Y. Iwata, K. Katagiri, K. Mizushima, K. Noda, S. Sato, T. Shirai, Y. Takei, E. Takeshita
  NIRS, Chiba-shi

Construction of new treatment facility as an extension of the existing HIMAC facility, in which all treatment room will be equipped with a 3D pencil beam scanning system, is in progress at NIRS. The challenge of this project is to realize treatment of a moving target by scanning irradiation, because pencil beam scanning is more sensitive to organ motions compared with the conventional broad-beam irradiation. To accomplish practical moving target irradiation, a prototype of the scanning irradiation system was constructed and installed into existing HIMAC physics experiment course. One of the most important features of the system to be tested is fast scanning toward moving target irradiation with a relatively large number of rescannings within an acceptable irradiation time. Commissioning of the prototype is successfully in progress cooperating with highly stabilized beam provided by the HIMAC accelerator complex. We will report the design of the system and the status of the beam study.

• Y. Iwata, T. Furukawa, K. Mizushima, K. Noda, T. Shirai, E. Takada, E. Takeshita
  NIRS, Chiba-shi
• T. Fujimoto, T. Kadowaki, Y. Sano, H. Uchiyama
  AEC, Chiba

Tumor therapy using energetic carbon ions, as provided by the HIMAC, has been performed since June 1994, and more than 5000 patients were treated until now. With the successful clinical results over more than ten years, we are constructing a new treatment facility. The new facility would have three treatment rooms; two of them have both horizontal and vertical fixed-irradiation-ports, and the other has a rotating-gantry-port. For all the ports, a scanning irradiation method is applied. The new facility is constructed in conjunction with the HIMAC, and heavy-ion beams will be provided by the HIMAC accelerators. To fulfill requirements for the scanning irradiation, we proposed multiple-energy operation with the quasi-DC extension of a flat top. With this operation, the beam energy can be successively varied within a single synchrotron-cycle, and therefore no energy degrader or the range shifter is required. The beam acceleration and extraction tests of the multiple-energy operation were successfully made. We will present the development of this operation as well as results of the beam acceleration tests.

• K. Mizushima, T. Furukawa, K. Noda, T. Shirai
  NIRS, Chiba-shi

The betatron tune fluctuation due to the current ripple of power supplies brings the beam spill ripple through the stable area variation in resonant slow extraction. The effect becomes dominant especially in the case of the low beam rate extraction. The RF-knockout slow extraction method is insensitive to the tune ripple compared to the ordinary one because it uses the diffusion with the transverse RF field. However, the ripple effect appears even in the beam spill extracted by it. The amount of the separatrix fluctuation due to the tune ripple depends on the difference between the bare and the resonant tune, and the sextupole magnetic strength. We measured the correlation between the beam spill and the tune ripple which was the artificially generated with low and high frequency components of 67 Hz and 1167 Hz near those of the real current ripple. We confirmed the reduction of the beam spill ripple by setting the tune away from the resonance while keeping the separatrix area. The comparison between the experimental results, the analytical calculation and the simulation will be reported.