• A. Pepato, R. Dima, F. Scantamburlo
  INFN- Sez. di Padova, Padova
• M. Comunian, E. Fagotti, F. Grespan, A. Palmieri, A. Pisent, C. Roncolato
  INFN/LNL, Legnaro (PD)
• D. Dattola, P. Mereu
  INFN-Torino, Torino

In the framework of the IFMIF/EVEDA project, the RFQ is a 9.8 m long cavity, with very challenging mechanicals specification. In the base line design, the accelerator tank is composed of 18 modules that are flanged together. The construction procedure of each module foresees the horizontal brazing of the four electrodes and then the vertical brazing of the flanges. A RFQ prototype, composed of 2 modules, aimed at testing all the mechanical construction procedure is under construction. In this article, the progress of the prototype construction and the progresses in the design and engineering phase, as well the description of all the fabrication phases is reported.

• A. Palmieri, F. Grespan
  INFN/LNL, Legnaro (PD)
• G. Cotto
  Torino University, ., Torino
• D. Dattola, P. Mereu
  INFN-Torino, Torino

In order to validate the tuning and stabilization procedures established for the IFMIF RFQ, a campaign of low power tests on an aluminum real-scale RFQ built on purpose has been carried out. Such campaign consisted of the determination of mode spectra, the measurements of the electric field distribution with bead pulling technique, and the implementation of the tuning procedure. The main outcomes and results obtained are reported in the article.