• Y.I. Kim, A. Heo, E.-S. Kim
  Kyungpook National University, Daegu
• S.T. Boogert
  Royal Holloway, University of London, Surrey
• Y. Honda, T. Tauchi, N. Terunuma
  KEK, Ibaraki
• J. May, D.J. McCormick, T.J. Smith
  SLAC, Menlo Park, California

Nanometer resolution Beam Position Monitors have been developed to measure and control beam position stability at the interaction point region of ATF2. The position of the beam focused has to be measured within a few nanometer resolution at the interaction point. In order to achieve this performance, electronics for this BPM was developed. Every component of the electronics have been simulated and checked by local test and using beam signal. We will explain each component and define their working range. Then, we will show the performance of the electronics measured with beam signal.

• J. Alabau-Gonzalvo, C. Blanch Gutierrez, J.V. Civera, A. Faus-Golfe, J.J. García-Garrigós
  IFIC, Valencia
• J. Cruz, D.J. McCormick, G.R. White
  SLAC, Menlo Park, California

In this paper we describe the design, installation and first calibration tests of a Multi Optical Transition Radiation (OTR) monitor system in the beam diagnostic section of the Extraction (EXT) line of ATF2, close to the multi wire scanner system. This system will be a valuable tool for measuring beam sizes and emittances from the ATF Damping Ring (DR). With an optical resolution of about 2 um an original OTR design demonstrated the ability to measure a 5.5um beam size in one beam pulse and to take many fast measurements. This gives the OTR the ability to measure the beam emittance with high statistics, giving a low error and a good understanding of emittance jitter. Furthermore the near by wire scanners will be a definitive test of the OTR as a beam emittance diagnostic device. The muti-OTR system design proposed here is based on the existing OTR1X, located after the septums at the entrance of the EXT line.

• M.P. Dunning, E.R. Colby, Y.T. Ding, J.T. Frederico, A. Gilevich, C. Hast, R.K. Jobe, D.J. McCormick, J. Nelson, T.O. Raubenheimer, K. Soong, G.V. Stupakov, Z.M. Szalata, D.R. Walz, S.P. Weathersby, M. Woodley, D. Xiang
  SLAC, Menlo Park, California
• J.N. Corlett, G. Penn, S. Prestemon, J. Qiang, D. Schlueter, M. Venturini, W. Wan
  LBNL, Berkeley, California
• P.L. Pernet
  EPFL, Lausanne

In this paper we describe the technical design of an on-going proof-of-principle echo-enabled harmonic generation (EEHG) FEL experiment in the Next Linear Collider Test Accelerator (NLCTA) at SLAC. The experiment was designed through late 2009 and built and installed between October 2009 and January 2010. We present the design considerations, the technical realization and the expected performances of the EEHG experiment.

• D. Xiang, E.R. Colby, Y.T. Ding, M.P. Dunning, J.T. Frederico, A. Gilevich, C. Hast, R.K. Jobe, D.J. McCormick, J. Nelson, T.O. Raubenheimer, K. Soong, G.V. Stupakov, Z.M. Szalata, D.R. Walz, S.P. Weathersby, M. Woodley
  SLAC, Menlo Park, California
• J.N. Corlett, G. Penn, S. Prestemon, J. Qiang, D. Schlueter, M. Venturini, W. Wan
  LBNL, Berkeley, California
• P.L. Pernet
  EPFL, Lausanne

ECHO-7 is a proof-of-principle echo-enabled harmonic generation* FEL experiment in the Next Linear Collider Test Accelerator (NLCTA) at SLAC. The experiment aims to generate coherent radiation at 318 nm and 227 nm, which is the 5th and 7th harmonic of the infrared seed laser. In this paper we present the preliminary results from the commissioning run of the completed experimental setup which started in April 2010.

* G. Stupakov, PRL, 102, 074801 (2009); D. Xiang and G. Stupakov, PRST-AB, 12, 030702 (2009).

• S.T. Boogert, G.E. Boorman, C. Swinson
  JAI, Oxford
• R. Ainsworth, S. Molloy
  Royal Holloway, University of London, Surrey
• A.S. Aryshev, Y. Honda, T. Tauchi, N. Terunuma, J. Urakawa
  KEK, Ibaraki
• J.C. Frisch, J. May, D.J. McCormick, J. Nelson, T.J. Smith, G.R. White, M. Woodley
  SLAC, Menlo Park, California
• A. Heo, E.-S. Kim, H.-S. Kim, Y.I. Kim
  Kyungpook National University, Daegu
• A. Lyapin
  UCL, London
• H.K. Park
  KNU, Deagu
• M.C. Ross
  Fermilab, Batavia
• S. Shin
  PLS, Pohang

The Accelerator Test Facility 2 (ATF2) in KEK, Japan, is a prototype scaled demonstrator system for the final focus required for a lepton linear collider. The ATF2 beam-line is instrumented with a total of 38 C and S band resonant cavity beam position monitors (BPM) with associated mixer electronics and digitizers. The current status of the BPM system is described, with a focus on operational techniques and performance.