• T.V. Shaftan, A. Blednykh, Y. Kawashima, S. Krinsky, J. Rose, L.-H. Yu
  BNL, Upton, Long Island, New York

Booster extraction presents a number of problems that include strengths and waveforms of the pulsed magnets and design of the vacuum chamber. Instabilities in the booster extraction may compromise the extracted beam quality deteriorating value of high-performance injector design. Here we discuss requirements and tolerances for the extraction system components and methods of increasing its performance.

• W. Guo, S. Krinsky, L. Yang
  BNL, Upton, Long Island, New York

Chromaticity is usually set to non-zero value at the third generation light sources to cure the intensity induced instabilities. It is effective in suppressing the beam centroid oscillation; however, it is repeatedly reported that the beam lifetime decreases significantly when chromaticity goes up. This is probably due to the crossing of resonance lines by the enlarged tune footprint. In this paper we optimize the NSLS-II lattice at different positive chromaticity settings. The tune footprint is adjusted to fit in the stable region divided by the strong resonance lines. Tracking results show that we can maintain a lifetime similar to that of the zero-chromaticity lattice solutions.

• W. Guo, S.L. Kramer, S. Krinsky, B. Nash, J. Skarita, F.J. Willeke
  BNL, Upton, Long Island, New York

NSLS-II is a third-generation light source that is being built at the Brookhaven National Laboratory. The storage ring has 30 double-bend-achromatic cells. Six 3.5-m-long damping wigglers (DW) will be installed in three straight section to lower the emittance. The civil construction of the facility started in June 2009 and major accelerator components, such as magnets and vacuum chambers, have entered production phase. This paper will summarize the physics considerations for the NSLS-II magnet specifications. In particular, we discuss the tuning range required by the lattice flexibility, and the issues which lead to the specification for the higher-order multipoles.

• T.V. Shaftan, A. Blednykh, W.R. Casey, L.R. Dalesio, R. Faussete, M.J. Ferreira, R.P. Fliller, G.S. Fries, G. Ganetis, W. Guo, R. Heese, H.-C. Hseuh, Y. Hu, P.K. Job, E.D. Johnson, Y. Kawashima, B.N. Kosciuk, S. Kowalski, S. Krinsky, Y. Li, H. Ma, R. Meier, S. Ozaki, D. Padrazo, B. Parker, I. Pinayev, M. Rehak, J. Rose, S. Sharma, O. Singh, P. Singh, J. Skaritka, C.J. Spataro, G.M. Wang, F.J. Willeke, L.-H. Yu
  BNL, Upton, Long Island, New York

We discuss status and plans of development of the NSLS-II injector. The injector consists of 200 MeV linac, 3-GeV booster, transport lines and injection straight section. The system design is now nearly completed and the injector development is in the procurement phase. The injector commissioning is planned to take place in 2012.