• H. Maesaka, S.I. Inoue, S. Matsubara, Y. Otake
  RIKEN/SPring-8, Hyogo

The x-ray FEL facility at SPring-8 produces a very short-bunch beam by using bunch compressors (BC) consisting of magnetic chicanes. Since the bunch compression ratio is strongly depends on the beam energy and the energy chirp, we need to monitor the energy from the beam position at the dispersive part of the BC with a 0.1% resolution. However, a beam profile at the dispersive part is horizontally flat and wide, maximally 50 mm, due to the large energy chirp of the beam. Therefore, we designed a multi-stripline beam position monitor. This monitor has a flat rectangular duct with a 70 mm width and a 10 mm height. Six stripline electrodes at individual intervals of 10 mm are equipped on each of the top and the bottom surface. Due to the small height of the monitor, each electrode is sensitive to the electron position within 10 mm in the horizontal. Therefore, the monitor provides a rough charge profile and the beam position which is calculated from the gravity center of the signals. We prepared a prototype of the monitor and tested it at the SCSS test accelerator. We confirmed that the position sensitivity was better than 0.1 mm, which corresponds to 0.1 % energy resolution.