• A. Bertarelli, A. Dallocchio, L. Gentini, N. Mariani, R. Perret, M.A. Timmins
  CERN, Geneva

Phase II collimators will complement the existing system to improve the expected high RF impedance and limited efficiency of Phase I jaws. An international collaborative effort has been launched to identify novel advanced materials responding to the very challenging requirements of the new collimators. Complex numerical calculations simulating extreme conditions and experimental tests are in progress. In parallel, an innovative modular design concept of the jaw assembly is being developed to allow fitting in alternative materials, minimizing the thermally induced deformations, withstanding accidents and tolerate high radiation doses. Phase II jaw assembly is made up of a molybdenum back-stiffener ensuring high geometrical stability and a modular jaw split in threes sectors. Each sector is equipped with a high-efficiency independent cooling circuit. Beam position monitors (BPM) are embedded in the jaws to accelerate setup time and improve beam monitoring. An adjustment system will permit to fine-tune the jaw flatness just before commissioning the system. A full scale collimator prototype is being manufactured by CERN workshops to validate each feature of the new design.