• M. Petrarca, E. Chevallay, A.E. Dabrowski, M. Divall Csatari, S. Döbert, D. Egger, V. Fedosseev, T. Lefèvre, R. Losito, O. Mete
  CERN, Geneva

The high charge PHIN photo injector is studied at CERN as an electron source for the CLIC Test Facility (CTF3) drive beam as an alternative to the present thermionic gun. The objective of PHIN is to demonstrate the feasibility of a laser-based electron source for CLIC. The photo injector operates with a 2.5 cell, 3 GHz RF gun using a Cs2Te photocathode illuminated by UV laser pulses generated by amplifying and frequency quadrupling the signal from a Nd:YLF oscillator running at 1.5GHz. The challenge is to generate a beam structure of 1908μbunches with 2.33nC perμbunch at 1.5GHz leading to a high integrated train charge of 4446nC and nominal beam energy of 5.5MeV with current stability below 1%. In the present test stand, a segmented beam dump has been implemented allowing a time resolved measurement of the energy and energy spread of the electron beam. In this paper we report and discuss the measured transverse and longitudinal beam parameters for both the full and time gated train of bunches, and the obtained photocathode quantum efficiency. Laser pointing and amplitude stability results are discussed taking into account correlation between laser and electron beam.