ICALEPCS2015 - List of Authors (Boivin, J-P.)

Paper	Title	Page
MOPGF104	Consolidations on the Vacuum Controls of the CERN Accelerators, During the First Long Shutdown of the LHC	322
	P. Gomes, F. Antoniotti, F. Aragon, F. Bellorini, S. Blanchard, J-P. Boivin, N. Chatzigeorgiou, F. Daligault, R. Ferreira, J. Fraga, J. Gama, A. Gutierrez, P. Krakówski, H.F. Pereira, G. Pigny, P.P. Prieto, B. Rio, H. Vestergard CERN, Geneva, Switzerland L. Kopylov, S. Merker, M.S. Mikheev IHEP, Moscow Region, Russia
	For two years (Spring 2013 - Spring 2015), the LHC went through its first long shutdown (LS1). It was mainly motivated by the consolidation of magnet interconnects, to allow operation with 6.5 TeV proton beams. Moreover, around the accelerator complex, many other systems were repaired, consolidated or upgraded, and several new installations came to life. The standardization of vacuum controls has progressed in the injectors, with the renovation of most of their obsolete equipment. In the LHC, many new instruments were added, the signal transmission integrity was improved, and the exposure to radiation was reduced in critical places. Several developments were needed for new equipment types or new operational requirements.
	Poster MOPGF104 [16.021 MB]
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

MOPGF112	Measurements, Alarms and Interlocks in the Vacuum Control System of the LHC	338
	G. Pigny, F. Antoniotti, J-P. Boivin, N. Chatzigeorgiou, J. Gama, P. Gomes, P. Krakówski, H.F. Pereira CERN, Geneva, Switzerland
	In the LHC beam pipes and cryostats, the pressure measurement covers a wide range, from 1500 mbar down to 10^-11 mbar and even lower. If vacuum deteriorates, alarm signals are generated and sent to other systems, e.g. cryogenics, accelerating cavities, kicker magnets, and beam interlock. In addition, an unacceptable pressure rise in beam pipes generates interlocks to close the adjacent sector valves, thus isolating the sector, so that the pressure rise does not propagate. This paper describes the measurement chains, the alarms and interlocks logic used in the vacuum control system of the LHC. We analyze the possible signal degradation caused by ionizing radiation or due to cable length, shielding and grounding. The weaknesses of the existing vacuum measurement system are pointed out, and a prospective for improvement of the conditioning electronics is proposed. During the first LHC long shut down, several corrections were applied; the results of the tests after commissioning are also presented.
	Poster MOPGF112 [1.749 MB]
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

Paper

Title

Page

Consolidations on the Vacuum Controls of the CERN Accelerators, During the First Long Shutdown of the LHC

322

P. Gomes, F. Antoniotti, F. Aragon, F. Bellorini, S. Blanchard, J-P. Boivin, N. Chatzigeorgiou, F. Daligault, R. Ferreira, J. Fraga, J. Gama, A. Gutierrez, P. Krakówski, H.F. Pereira, G. Pigny, P.P. Prieto, B. Rio, H. Vestergard
CERN, Geneva, Switzerland
L. Kopylov, S. Merker, M.S. Mikheev
IHEP, Moscow Region, Russia

For two years (Spring 2013 - Spring 2015), the LHC went through its first long shutdown (LS1). It was mainly motivated by the consolidation of magnet interconnects, to allow operation with 6.5 TeV proton beams. Moreover, around the accelerator complex, many other systems were repaired, consolidated or upgraded, and several new installations came to life. The standardization of vacuum controls has progressed in the injectors, with the renovation of most of their obsolete equipment. In the LHC, many new instruments were added, the signal transmission integrity was improved, and the exposure to radiation was reduced in critical places. Several developments were needed for new equipment types or new operational requirements.

Poster MOPGF104 [16.021 MB]

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

MOPGF112

Measurements, Alarms and Interlocks in the Vacuum Control System of the LHC

338

G. Pigny, F. Antoniotti, J-P. Boivin, N. Chatzigeorgiou, J. Gama, P. Gomes, P. Krakówski, H.F. Pereira
CERN, Geneva, Switzerland

In the LHC beam pipes and cryostats, the pressure measurement covers a wide range, from 1500 mbar down to 10^-11 mbar and even lower. If vacuum deteriorates, alarm signals are generated and sent to other systems, e.g. cryogenics, accelerating cavities, kicker magnets, and beam interlock. In addition, an unacceptable pressure rise in beam pipes generates interlocks to close the adjacent sector valves, thus isolating the sector, so that the pressure rise does not propagate. This paper describes the measurement chains, the alarms and interlocks logic used in the vacuum control system of the LHC. We analyze the possible signal degradation caused by ionizing radiation or due to cable length, shielding and grounding. The weaknesses of the existing vacuum measurement system are pointed out, and a prospective for improvement of the conditioning electronics is proposed. During the first LHC long shut down, several corrections were applied; the results of the tests after commissioning are also presented.

Poster MOPGF112 [1.749 MB]

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)