PSI, Villigen PSI, Switzerland
* F. Marcellini et al., "Design of Cavity BPM Pickups For SwissFEL", Proc. IBIC'12, Tsukuba, Japan, 2012.
** B. Keil et al., "The European XFEL BPM System", Proc. IPAC'10, Kyoto, Japan, 2010.
| Paper | Title | Page |
|---|---|---|
| TUPC25 | Design of the SwissFEL BPM System | 427 |
|
||
|
SwissFEL is a Free Electron Laser (FEL) facility being constructed at PSI, based on a 5.8GeV normally conducting main linac. A photocathode gun will generate two bunches with 28ns spacing at 100Hz repetition rate, with a nominal charge range of 10-200pC. A fast beam distribution kicker will allow to distribute one bunch to a soft X-ray undulator line and the other bunch to a 0.1nm hard X-ray undulator line. The SwissFEL electron beam position monitor (BPM) system will employ three different types of dual-resonator cavity BPMs, since the accelerator has three different beam pipe apertures. In the injector and main linac (38mm and 16mm aperture), 3.3GHz cavity BPMs will be used, where a low Q of ~40 was chosen to minimize crosstalk of the two bunches*. In the undulators that just have single bunches and 8mm BPM aperture, a higher Q will be chosen. This paper reports on the development status of the SwissFEL BPM system. Synergies as well as differences to the E-XFEL BPM system** will also be highlighted.
* F. Marcellini et al., "Design of Cavity BPM Pickups For SwissFEL", Proc. IBIC'12, Tsukuba, Japan, 2012. ** B. Keil et al., "The European XFEL BPM System", Proc. IPAC'10, Kyoto, Japan, 2010. |
||
|
|
Poster TUPC25 [1.074 MB] | |