INFN/PG, Perugia
ESA-ESTEC, Noordwijk
INFN/LNS, Catania
MapRad, Perugia
Abant Izzet Baysal Üniversitesi, Bolu
ODTU/Phys. Dept., Ankara
This paper describes the beam monitoring system that has been developed at the Superconducting Cyclotron at INFN-LNS (Istituto Nazionale di Fisica Nucleare, Laboratori Nazionali del Sud, Catania, Italy) in order to monitor the beam parameters such as energy, flux, beam profile, for SEE (Single Event Effects) cross-sections determination and DD (Displacement Damage) studies. In order to have an accurate and continuous monitoring of beam parameters we have developed fully automatic dosimetry setup to be used during SEE (with heavy ions) and DD (with protons of 60 MeV/n) tests of electronic devices and systems. The final goal of our activity is to demonstrate how operating in air, which in our experience is easier than in vacuum, is not detrimental to the accuracy on controlling the beam profile, energy and fluence delivered onto the DUT (Device Under Test) surface, even with non relativistic heavy ions. We have exposed during the same session, two beam calibration systems, the "Reference SEU monitor" developed by ESA/ESTEC and the beam monitoring and dosimetry setup developed by our group. The results are compared and discussed here.
