ECRIS2012 - List of Authors (Peters, C.E.)

Paper	Title	Page
WEPP17	A Multi-Sample Changer Coupled to an ECR Source for AMS Experiments	146
	R.C. Vondrasek, T. Palchan, R.C. Pardo, C.E. Peters, M.A. Power, R.H. Scott ANL, Argonne, USA
	Funding: This work was supported by the U.S. Department of Energy, Office of Nuclear Physics, under Contract No. DE-AC02-06CH11357. A project using Accelerator Mass Spectrometry (AMS) at the ATLAS facility to measure neutron capture rates on a wide range of actinides in a reactor environment is underway. This project will require the measurement of a large number of samples previously irradiated in the Advanced Test Reactor at Idaho National Laboratory. The AMS technique at ATLAS is based on production of highly-charged positive ions in an electron cyclotron resonance ion source (ECRIS) followed by acceleration in the ATLAS linac. The sample material is introduced into the plasma via laser ablation. This should limit the dependency of material feed rates upon the source material composition as well as minimize cross-talk between samples. A new multi-sample changer has been constructed allowing rapid changes between samples. The sample changer has 20 positions and is capable of moving from one sample to the next in one minute. Details of the sample changer design and operation will be presented.

Paper

Title

Page

A Multi-Sample Changer Coupled to an ECR Source for AMS Experiments

146

R.C. Vondrasek, T. Palchan, R.C. Pardo, C.E. Peters, M.A. Power, R.H. Scott
ANL, Argonne, USA

Funding: This work was supported by the U.S. Department of Energy, Office of Nuclear Physics, under Contract No. DE-AC02-06CH11357.
A project using Accelerator Mass Spectrometry (AMS) at the ATLAS facility to measure neutron capture rates on a wide range of actinides in a reactor environment is underway. This project will require the measurement of a large number of samples previously irradiated in the Advanced Test Reactor at Idaho National Laboratory. The AMS technique at ATLAS is based on production of highly-charged positive ions in an electron cyclotron resonance ion source (ECRIS) followed by acceleration in the ATLAS linac. The sample material is introduced into the plasma via laser ablation. This should limit the dependency of material feed rates upon the source material composition as well as minimize cross-talk between samples. A new multi-sample changer has been constructed allowing rapid changes between samples. The sample changer has 20 positions and is capable of moving from one sample to the next in one minute. Details of the sample changer design and operation will be presented.