DIPAC2011 - List of Authors (Boccard, C.B.)

Paper

Title

Page

Electromagnetic Simulations of an Embedded BPM in Collimator Jaws

71

A.A. Nosych, C.B. Boccard, M. Gasior
CERN, Geneva, Switzerland

Next generation of the LHC collimators will be equipped with button beam position monitors (BPMs) embedded into the collimator jaws. Such a solution will improve the accuracy of the jaw alignment with respect to the beam and reduce the beam time necessary for the collimator setup. This paper describes results of electromagnetic simulations of the jaw BPMs performed with the CST Particle Studio suite, aimed at characterisation of the BPMs as well as the simulation software itself. The results are compared to the measurements obtained with beam on a prototype system installed in the CERN SPS.

Poster MOPD15 [6.439 MB]

MOPD18

Embedded Collimator Beam Position Monitors

80

C.B. Boccard, A. Bertarelli, A. Dallocchio, M. Gasior, L. Gentini, A.A. Nosych
CERN, Geneva, Switzerland

The LHC collimation system is crucial for safe and reliable operation of proton beams with 350 MJ stored energy. Currently the collimator set-up is performed by observing beam losses when approaching the collimator jaws to the beam. For all 100 LHC movable collimators the procedure may take several hours and since it has to be repeated whenever the beam configuration changes significantly, the collimator setup has an important impact on the overall machine operation efficiency. To reduce the collimator setup time by two orders of magnitude the next generation of the LHC collimators will be equipped with button beam position monitors (BPMs) embedded into the collimator jaws. This paper describes the BPM design and presents prototype results obtained with beam in the CERN-SPS.

Poster MOPD18 [1.729 MB]

Paper	Title	Page
MOPD15	Electromagnetic Simulations of an Embedded BPM in Collimator Jaws	71
	A.A. Nosych, C.B. Boccard, M. Gasior CERN, Geneva, Switzerland
	Next generation of the LHC collimators will be equipped with button beam position monitors (BPMs) embedded into the collimator jaws. Such a solution will improve the accuracy of the jaw alignment with respect to the beam and reduce the beam time necessary for the collimator setup. This paper describes results of electromagnetic simulations of the jaw BPMs performed with the CST Particle Studio suite, aimed at characterisation of the BPMs as well as the simulation software itself. The results are compared to the measurements obtained with beam on a prototype system installed in the CERN SPS.
	Poster MOPD15 [6.439 MB]

MOPD18	Embedded Collimator Beam Position Monitors	80
	C.B. Boccard, A. Bertarelli, A. Dallocchio, M. Gasior, L. Gentini, A.A. Nosych CERN, Geneva, Switzerland
	The LHC collimation system is crucial for safe and reliable operation of proton beams with 350 MJ stored energy. Currently the collimator set-up is performed by observing beam losses when approaching the collimator jaws to the beam. For all 100 LHC movable collimators the procedure may take several hours and since it has to be repeated whenever the beam configuration changes significantly, the collimator setup has an important impact on the overall machine operation efficiency. To reduce the collimator setup time by two orders of magnitude the next generation of the LHC collimators will be equipped with button beam position monitors (BPMs) embedded into the collimator jaws. This paper describes the BPM design and presents prototype results obtained with beam in the CERN-SPS.
	Poster MOPD18 [1.729 MB]