| Paper |
Title |
Page |
| WEPP068 |
Impact Distribution of the Beam Losses at the LHC Collimators in Case of Magnet Failures
|
2674 |
| |
- A. Gomez Alonso
CERN, Geneva
|
|
| |
During LHC operation, magnet failures may affect the beam optics leading to proton losses in the collimators. These losses, with about 360MJ of stored energy per beam at nominal collision operation, are potentially dangerous for the accelerator equipment. The LHC Machine Protection Systems ensure that the beam is extracted safely before these losses can produce any damage. As a magnet failure develops, so does the distribution of the lost particles, longitudinally along the ring as well as transversally at each collimator. The transversal impact distributions of lost particles at the most affected collimators and their evolution with time have been studied for representative magnet failures in the LHC. It has been found that the impact distribution at a given collimator can be approximated by an exponential function with time-dependent parameters. The average impact parameter ranges from about 7 to 620 μm for the cases studied.
|
|
| WEPP069 |
Tracking Tools to Estimate the Quench Time Constants for Magnet Failures in LHC
|
2677 |
| |
- A. Gomez Alonso
CERN, Geneva
|
|
| |
At LHC, beam losses, with about 360MJ of stored energy per beam at nominal collision operation, are potentially dangerous for the accelerator equipment and can also affect the operational efficiency by inducing quenches in superconducting magnets. Magnet failures may affect the beam leading to proton losses primarily in collimators and secondary in superconducting magnets due to scattering of protons from collimator jaws. The evolution of the beam during magnet failures has been simulated using MAD-X with a variable magnetic field. The impacts of particles in the collimators have been recorded as a function of time. A second program, CollTrack, has been used to determine the loss patterns of scattered particles from each collimator as a function of the initial impact parameter. The magnets that are likely to quench are identified and an estimation of the time between the beginning of a failure and a quench is obtained by combining the results from the simulations. The time to a start of a quench is a relevant parameter to determine the dump threshold of beam loss monitors in order to optimize protection redundancy and operation smoothness for LHC.
|
|