| Paper |
Title |
Page |
| TUPLT187 |
SNS Extraction Kicker Power Supply Control
|
1568 |
| |
- J.-L. Mi, L. Hoff, R.F. Lambiase, Y.Y. Lee, J. Sandberg, Y. Tan, N. Tsoupas, R. Zapasek, W. Zhang
BNL, Upton, Long Island, New York
|
|
| |
There are fourteen PFN power supplies, which will be installed in the SNS Extraction Kicker System. This paper will introduce these fourteen-power supplies arrangement and control schematic. These control instruments and boards are installed into four standard racks. Some of the control boards functions will be list in this paper. Control racks and some control boards pictures will be shown in this paper.
|
|
| TUPLT188 |
SNS Extraction Kicker Power Supply Manufacture Status
|
1571 |
| |
- J.-L. Mi, H. Hahn, R.F. Lambiase, Y.Y. Lee, C. Pai, J. Sandberg, Y. Tan, N. Tsoupas, D.S. Warburton, R. Zapasek, W. Zhang
BNL, Upton, Long Island, New York
|
|
| |
There are fourteen PFN power supplies, which will be installed in the SNS Extraction Kicker System. The Pulse Forming Network (PFN) power supplies for the SNS Extraction kicker were designed by Brookhaven. The basic configuration of the PFN is a lumped element Blumlein pulse forming network (BPFN). The PFN and power supply are fabricated by an industrial company. The first article of. PFN and power supply has been manufactured and tested with a dummy load at the company and onsite with the prototype magnet. The PFN has been tested beyond its specification and has met all requirements including rise time, pulse flatness, amplitude and pulse repetition rate. Additional heat runs are scheduled. The transverse coupling impedance of the kicker system with attached PFN has been measured. This paper will report on the SNS Extraction Kicker Power Supply engineering status, and will include output waveforms, impedance measurements, and production projections.
|
|