| Paper |
Title |
Page |
| TUPLT033 |
RF Design of the MAFF IH-RFQ Power Resonator
|
1216 |
| |
- M. Pasini, D. Habs, O. Kester
LMU, München
- T. Sieber
CERN, Geneva
|
|
| |
The low energy part of the LINAC of the MAFF facility will be an IH-RFQ cavity with 101.28 MHz resonance frequency. The RF design of the cavity has been completed, including design calculations and model measurements. The RFQ is designed to deliver ions of A/q = 6.5 up to 300 keV/u to be injected into the following LINAC. The structure chosen was an IH type of resonator since it was demontrated to have a better shunt impedance. The required voltage between the electrodes is 70kV and the operation mode is pulsed with a duty cycle of 10%. The structure will be made out from bulk copper in order to improve the shunt impedance and hence to allow not direct cooling on the electrodes. The optimizazion of the several parameters of the structure, and the technique for tuning the voltage distribution are presented in this paper. Measurements with a short model will be shown as well.
|
|