| Paper |
Title |
Page |
| MOPLT089 |
SOS-diode Based Pulser for the Injection System of the Collider VEPP-2000
|
743 |
| |
- F.V. Podgorny, B.I. Grishanov, A.S. Kasaev
BINP SB RAS, Novosibirsk
|
|
| |
We describe high voltage pulsers for supplying of kickers of the collider VEPP-2000 injection system. The high voltage pulse is formed as a result of a sharp break of a high current, accumulated previously in storage elements, by means SOS-diode. Pulse forming lines or inductances could be used as the storage elements. The generators form the quasi-rectangular pulses on the 50-Ohm load. The generator scheme is described also.
|
|
| MOPLT090 |
High Pulse and Average Power Low-induction Load
|
746 |
| |
- F.V. Podgorny, B.I. Grishanov
BINP SB RAS, Novosibirsk
|
|
| |
A high pulse and average power low-induction load with a built-in divider is described in this report. The load has a nominal resistance of 25 Ohm and is designed to operate with a repetition rate of up to 50 Hz at a pulse duration (FWHM) of 100 ns, a rise/fall time of 50 ns and a pulse amplitude of up to 40 kV. In this mode the dissipated energy is equal to about 8 J per pulse and average power is up to 400 W. The load can be used as an absorbing load and as a block element in high-voltage engineering.
|
|