| |
Accurate conventional combined magnets working in saturation are currently required to fulfil the increasing demands on low emittance accelerators with long straight sections required by the newest Synchrotron Light Sources. This fact yields stringent requirements on pole profile design, manufacture and characterization. The aim of this poster is to present a general method for designing two-dimensional pole profiles. To this end, we have set up a procedure with which to select an optimum pole profile in 2D without the constraint of relying on a set of initial assumptions, not only a particular set of initial parameters but even a particular pole profile model. Moreover, we have developed a group of codes that can be compiled and run on MS-DOS or UNIX which use POISSON or OPERA-2d codes. This procedure also includes the evaluation of the sensitivity of the final pole profile to geometrical and current intensity errors for tolerance estimation, a big requirement in this context. In order to test the feasibility of this method, we have applied it to the case of the 1.2 T combined magnet of the new synchrotron to be built nearby Barcelona.
|
|