| Paper |
Title |
Page |
| MOPLT153 |
Electron-Ion Collider at CEBAF: New Insights and Conceptual Progress
|
893 |
| |
- Y.S. Derbenev, A. Afanasev, K. Beard, S.A. Bogacz, P. Degtiarenko, J.R. Delayen, A. Hutton, G.A. Krafft, R. Li, L. Merminga, M. Poelker, B.C. Yunn, Y. Zhang
Jefferson Lab, Newport News, Virginia
- P.N. Ostroumov
ANL/Phys, Argonne, Illinois
|
|
| |
We report on progress in conceptual development of the proposed high luminosity (up to 1035/cm2s) and efficient spin manipulation (using figure 8 boosters and collider rings) Electron-Ion Collider at CEBAF based on use of polarized 5-7 GeV electrons in superconduction energy recovering linac (ERL with circulator ring, kicker-operated) and 30-150 GeV ion storage ring (polarized p, d. He3, Li and unpolarized nuclei up to Ar, all totally stripped). Ultra-high luminosity is envisioned to be achievable with short ion bunches and crab-crossing at 1.5 GHz bunch collision rate interaction points. Our recent studies concentrated on simulation of beam-beam interaction, preventing the electron cloud instability, calculating luminosity lifetime due to Touschek effect in ion beam and background scattering of ions, experiments on energy recovery at CEBAF, and other. These studies have been incorporated in the development of the luminosity calculator and in formulating minimum requirements to the polarized electron and ion sources
|
|
| TUPLT165 |
A PARMELA Model of the CEBAF Injector valid over a Wide Range of Parameters
|
1515 |
| |
- Y. Zhang, K. Beard, F.J. Benesch, Y.-C. Chao, A. Freyberger, J.M. Grames, R. Kazimi, G.A. Krafft, R. Li, L. Merminga, M. Poelker, M. Tiefenback, B.C. Yunn
Jefferson Lab, Newport News, Virginia
|
|
| |
A pre-existing PARMELA model of the CEBAF injector has been recently verified using machine survey data and also extended to 60 MeV region. The initial distribution and temperature of an electron bunch are determined by the photocathode laser spot size and emittance measurements. The improved injector model has been used for extensive computer simulations of the simultaneous delivery of the Hall A beam required for a hypernuclear experiment, and the Hall C beam, required for a parity experiment. The Hall C beam requires a factor of 6 higher bunch charge than the Hall A beam, with significantly increased space charge effects, while the Hall A beam has an exceedingly stringent energy spread requirement of 2.5x 10-5 rms. Measurements of the beam properties of both beams at several energies (100 keV, 500 keV, 5 MeV, 60 MeV) and several values of the bunch charge were performed using the standard quad-wire scanner technique. Comparisons of simulated particle transmission rate, longitudinal beam size, transverse emittance and twiss parameters, and energy spread against experimental data yield reasonably good agreement. The model is being used for searching for optimal setting of the CEBAF injector.
|
|