| Paper |
Title |
Page |
| TUPKF012 |
A HOM Damped Planar Accelerating Structure
|
982 |
| |
- A. Blednykh, H. Henke
TET, Berlin
|
|
| |
The problem of very fast higher order mode (HOM) suppression, in the order of 1ns, was investigated for a planar 30GHz accelerating structure. Both, damping and detuning were considered. A sufficient suppression could be achieved by damping waveguides in every cell in vertical and in horizontal direction. Finally, a scaled-up 10GHz model was built. It is a 35 cm long aluminum structure, which was machined by high-precision milling. In order to reduce the surface gradient on the input/output coupling irises a symmetrical RF coupler was developed. The HOM damping is accomplished by coupling six damping waveguides to each accelerating cell. The waveguides are loaded by a low resitivity RF load. The whole structure with waveguides and loads was optimized by means of the computer code GdfidL. The paper gives the design criteria and the results of s-parameter and bead-pull measurements.
|
|
| THPLT028 |
High Precision Cavity Beam Position Monitor
|
2532 |
| |
- A. Liapine, H. Henke
TET, Berlin
|
|
| |
A cavity beam position monitor is proposed for measuring the beam deflection in the TESLA energy spectrometer. The precision of the measurement has to be better than 1 micrometer. A slotted cavity is chosen as pick-up in order to reject the background signals and enhance the precision and the dynamic range of the monitor. The paper gives the design overview for two prototypes with operating frequencies of 1.5 GHz and 5.5 GHz, respectively. The results obtained on the test bench with direct conversion electronics are presented. A resolution of about 100 nm was achieved.
|
|