| Paper |
Title |
Page |
| WEPKF026 |
Kicker Pulser with High Stability for the BESSY FEL
|
1654 |
| |
- J. Feikes, O. Dressler, J. Kuszynski
BESSY GmbH, Berlin
|
|
| |
In the BESSY FEL design a kicker system is forseen to extract electron bunches from the main LINAC into two FEL beam lines, beside the straigth main beamline. Sine half wave pulsers with a repetion rate of up to 1 kHz and modest pulse currents of 120A will be used. To receive the maximum FEL gain, it is crucial, that the extracted bunches enter well centered into the undulators. Hence, the extraction demands for very high short-term stability of the magnetic field (shot to shot). A kicker pulse amplitude with a relative amplitude jitter smaller than 5* 10-5 would be tolerable ?more than one order smaller than the jitter of conventional BESSY II kicker systems in use. A new highly stable semiconductor based kicker pulser prototype was designed, built and tested at BESSY. It was shown that the stability of the pulse current fulfills the FEL requirements. The pulser design, its layout and the corresponding pulse current jitter measurements are presented.
|
|
| WEPLT050 |
Frequency Map Measurements at BESSY
|
1948 |
| |
- P. Kuske, O. Dressler
BESSY GmbH, Berlin
|
|
| |
With two dedicated diagnostic kicker magnets and a turn-by-turn, bunch-by-bunch beam position monitor frequency maps were measured under various operating conditions of the BESSY storage ring. Depending on the number and type of insertion devices in operation additional resonances show up. Details of the experimental setup as well as the data analysis are presented. The results will be compared with theoretical calculations which are based on the linear model of the storage ring lattice extracted from measured response matrices. Non-linear elements are added to the model in order to describe the effect of the strong sextupole magnets, the horizontal corrector magnets installed in these magnets, and of some of the insertion devices.
|
|