A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z    

Danilov, V.V.

Paper Title Page
TUPLT166 Beam Invariants for Diagnostics 1518
 
  • V.V. Danilov, A.V. Aleksandrov
    ORNL/SNS, Oak Ridge, Tennessee
  
  This paper deals with some measurable quantities of beams preserved under symplectic transformations. General beam distributions have no determined area, and rms quantities of the beam do not provide invariants in general nonlinear case. It is shown, though, that in the 1D case there exist some integral and local invariants, directly linked to Liouville's theorem. Beam invariants, related to general properties of symplectic transformations, are also found and presented for 2D and 3D cases. If measured at different locations, they can tell whether the transformation is symplectic or there exist diffusion, friction, or other non-Hamiltonian dynamic processes in the beam.  
TUPLT168 SNS Beam Commisioning Status 1524
 
  • S. Henderson, A.V. Aleksandrov, S. Assadi, W. Blokland, C. Chu, S.M. Cousineau, V.V. Danilov, G.W. Dodson, J. Galambos, M. Giannella, D.-O. Jeon, S. Kim, L.V. Kravchuk, M.P. Stockli, E. Tanke, R.F. Welton, T.L. Williams
    ORNL/SNS, Oak Ridge, Tennessee
  
  The Spallation Neutron Source accelerator systems will provide a 1 GeV, 1.44 MW proton beam to a liquid mercury target for neutron production. The accelerator complex consists of an H- injector capable of producing 38 mA peak current, a 1 GeV linear accelerator, an accumulator ring and associated transport lines. The linear accelerator consists of a Drift Tube Linac, a Coupled-Cavity Linac and a Superconducting Linac which provide 1.5 mA average current to the accumulator ring. The staged beam commissioning of the accelerator complex is proceeding as component installation progresses. In three separate beam commissioning runs, the H- injector and Drift Tube Linac tanks 1-3 have been commissioned at ORNL. Several important performance goals have been achieved, namely 38 mA peak beam current, 1 msec beam pulse length and 1 mA average beam current. Results and status of the beam commissioning program will be presented.  
TUPLT170 The SNS Beam Power Upgrade 1527
 
  • S. Henderson, S. Assadi, R. Cutler, V.V. Danilov, G.W. Dodson, R.E. Fuja, J. Galambos, J.A. Holmes, N. Holtkamp, D.-O. Jeon, S. Kim, L.V. Kravchuk, M.P. McCarthy, G.R. Murdoch, D.K. Olsen, T.J. Shea, M.P. Stockli
    ORNL/SNS, Oak Ridge, Tennessee
  
  The Spallation Neutron Source (SNS) accelerator systems, which consist of an H- injector, a 1 GeV linear accelerator, an accumulator ring and associated transport lines, will provide a 1 GeV, 1.44 MW proton beam to a liquid mercury target for neutron production. The SNS is presently under construction at Oak Ridge National Laboratory and will begin operations in 2006. Even in the baseline design, many of the accelerator subsystems are capable of supporting higher beam intensities and higher beam energy. We report on upgrade scenarios for the SNS accelerator systems which increase the 1.44 MW baseline beam power to at least 3 MW, and perhaps as high as 5 MW. The increased SNS beam power can be achieved primarily by increasing the H- ion source current, installing additional superconducting cryomodules to increase the final linac beam energy to 1.3-1.4 GeV, and modifying injection and extraction hardware in the ring to handle the increased beam energy. The upgrade beam parameters will be presented, the required hardware modifications will be described, and the beam dynamics implications will be discussed.  
TUPLT171 ORBIT Simulations of the SNS Accumulator Ring 1530
 
  • J.A. Holmes, S.C. Bunch, S.M. Cousineau, V.V. Danilov, S. Henderson, A. Shishlo
    ORNL/SNS, Oak Ridge, Tennessee
  • M. Plum
    LANL, Los Alamos, New Mexico
  • Y. Sato
    IUCF, Bloomington, Indiana
  
  As SNS undergoes construction, many detailed questions arise concerning strategies for commissioning and operating the accumulator ring. The ORBIT Code is proving to be an indispensible tool for addressing these questions and for providing guidance to the physicists and decision makers as operation draws near. This paper shows the application of ORBIT to a number of ring issues including exclusion of the HEBT RF cavities during commissioning, the detailed effect of the injection chicane magnets on the beam, the effects and correction of magnet alignment and multipole errors, debunching of the linac 402.5 MHz beam structure, the injection of self consistent uniform beam configurations, and initial electron cloud simulations.  
WEPLT170 Injection Schemes for Self Consistent Space Charge Distributions 2224
 
  • V.V. Danilov, S.M. Cousineau, S. Henderson, J.A. Holmes, M. Plum
    ORNL/SNS, Oak Ridge, Tennessee
  
  This paper is based on recently found sets of self-consistent 2D and 3D time-dependent space charge distributions. A subset of these distributions can be injection-painted into an accumulator ring, such as Spallation Neutron Source Ring, to produce periodic space charge conditions. The periodic condition guarantees zero space-charge-induced halo growth and beam loss during injection. Practical aspects of such schemes are discussed, and simulations of a few specific cases are presented.  
WEPLT171 Rotating Electromagnetic Field Trap for High Temperature Plasma and Charge Confinement 2227
 
  • V.V. Danilov
    ORNL/SNS, Oak Ridge, Tennessee
  
  This paper demonstrates that there exists a special combination of oscillating electromagnetic fields capable of trapping ultra high charge densities. Trapped particles undergo stable motion when their frequencies of oscillation are much higher than that of the ocillating field. Contrary to conventional electromagnetic traps, the motion in this dynamic trap is stable for arbitrarily high electromagnetic field amplitudes. This, in turn, leads to the possibility of using enormous electric and magnetic fields from RF or laser sources to confine dense ultrahigh temperature plasmas and particle beams.