| Paper |
Title |
Page |
| TUPLT099 |
A Kicker Pulse Power Supply with Low Jitter
|
1387 |
| |
- C.-S. Fann, J.-P. Chiou, S.Y. Hsu, K.-B. Liu
NSRRC, Hsinchu
|
|
| |
The performance of kicker pulse power supplies is the main parameter to increase injection efficiency of storage ring that is an important issue for laboratory of synchrotron radiation research. The output current waveform of a kicker pulse power supply with low timing jitter is our goal for years that must satisfy the Top-Up mode injection requirement of NSRRC. In the past years kicker pulse power supplies of storage ring of NSRRC are immersed in isolation oil to sustain high voltage operational environment that led difficult to maintain, electronic component degrading and uneasy to tune parameters. Air-cooling and air-isolation is adopted in the new design structure for kicker pulse power supply system and an pre-trigger unit MA2709A is installed to trigger thyratron tube CX1536A, a kicker pulse power supply with low timing jitter 1~2ns(p-p) is obtained and could satisfy for Top-Up mode injection and maintenance is more easier than before.
|
|
| THPKF044 |
The Improvement of NSRRC Linac for Top-up Mode Operation
|
2371 |
| |
- J.-Y. Hwang, J. Chen, J.-P. Chiou, K.-T. Hsu, S.Y. Hsu, K.H. Hu, T.C. King, C.H. Kuo, K.-K. Lin, C.-J. Wang, Y.-T. Yang
NSRRC, Hsinchu
- C.T. Pan
NTHU, Hsinchu
|
|
| |
The performance of the 50 MeV linac at the National Synchrotron Radiation Research Center (NSRRC) was examined and has been improved recently. The major improved items were 1) adopting a command-charging scheme to replace the resonance charging for the linac modulator; and 2) gun electronics. As a result, the beam quality was improved in terms of its energy spectrum and stability. The correlation between the improvement of beam quality and component upgrading is analyzed. The influence of the beam quality improvement to the recently proposed top-up mode operation in 2005 will also be discussed in this report.
|
|