| Paper | Title | Page |
|---|---|---|
| TUPC053 | Superconducting Positron Stacking Ring for CLIC | 1117 |
|
||
| The generation of polarized positrons for future colliders based on Compton storage rings is a promising method. A challenging key ingredient of this method is the necessary quasi-continuous positron injection into a stacking ring. The ordinary methods of multi-turn injection are not appropriate for this purpose, because the required number of injection-turns is a few hundred, and the emittance of the injected positron bunches is large. This paper describes a possible solution based on 5 GeV superconducting stacking ring, where a novel method of the combined longitudinal and transverse injection process is used to stack positrons. The ring dynamic aperture allows to inject the positron beam with normalized emittance up to 2000 micrometers during a few hundred turns. The injection efficiency is larger than 90% in simulation. The number of the injection turns is only limited by the synchrotron radiation power. The ring lattice and the results of injection simulations are presented. | ||
| WEPC051 | Effect of Compton Scattering on the Electron Beam Dynamics at the ATF Damping Ring | 2127 |
|
||
| Compton scattering provides one of the most promising scheme to obtain polarized positrons for the next generation of e+e− colliders. Moreover it is an attractive method to produce monochromatic high energy polarized gammas for nuclear applications and X-rays for compact light sources. In this framework a four-mirror Fabry-Perot cavity has been installed at the Accelerator Test Facility (ATF - KEK, Tsukuba, Japan) and will be used to produce an intense flux of polarized gamma rays by Compton scattering. For electrons at the energy of the ATF (1.28GeV) Compton scattering may result in a shorter lifetime due to the limited bucket acceptance. We have implemented the effect of Compton scattering on a 2D tracking code with a Monte-Carlo method. This code has been used to study the longitudinal dynamics of the electron beam at the ATF damping ring, in particular the evolution of the energy spread and the bunch length under Compton scattering. The results obtained are presented and discussed. Possible methods to observe the effect of Compton scattering on the ATF beam are proposed. | ||
| TUPO002 | High Flux Polarized Gamma Rays Production: First Measurements with a Four-mirror Cavity at the ATF | 1446 |
|
||
|
Funding: ANR, IN2P3 The next generation of e+/e- colliders will require the production of a very intense flux of gamma rays to allow polarized positrons to be produced in sufficient quantities. To demonstrate that this can be achieved a four-mirror cavity has recently been installed at the Accelerator Test Facility (ATF) at KEK to produce a high flux of polarized gamma rays by inverse Compton scattering. A four-mirror non-planar geometry is used to ensure the polarization of the gamma rays produced. The main mechanical features of the cavity are presented. A fibre amplifier is used to inject about 10W in the high finesse cavity with a gain of 1000. A digital feedback system is used to keep the cavity at the length required for the optimal power enhancement. First preliminary measurements show that on some beam crossings the interactions produce more than 25 photons with an average energy of about 24 MeV. Several upgrades currently in progress are described. |
||