A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Yoshida, M.Y.

Paper Title Page
MOPEB065 Liquid Hydrogen Absorber for MICE 421
 
  • S. Ishimoto, S. Suzuki
    KEK, Ibaraki
  • M.A. Green
    LBNL, Berkeley, California
  • Y. Kuno, M.Y. Yoshida
    Osaka University, Osaka
  • W. Lau
    OXFORDphysics, Oxford, Oxon
 
 

Liquid hydrogen absorbers for the Muon Ionization Cooling Experiment (MICE) have been developed, and the first absorber has been tested at KEK. In the preliminary test at KEK we have successfully filled the absorber with ~2 liters of liquid hydrogen. The measured hydrogen condensation speed was 2.5 liters/day at 1.0 bar. No hydrogen leakage to vacuum was found between 300 K and 20 K. The MICE experiment includes three AFC (absorber focusing coil) modules, each containing a 21 liter liquid hydrogen absorber made of aluminum. The AFC module has safety windows to separate its vacuum from that of neighboring modules. Liquid hydrogen is supplied from a cryocooler with cooling power 1.5 W at 4.2 K. The first absorber will be assembled in the AFC module and installed in MICE at RAL.

 
THPEC030 Design of the COMET Pion Capture Solenoid 4116
 
  • M.Y. Yoshida, M. Aoki, Y. Kuno, A. Sato
    Osaka University, Osaka
  • T. Nakamoto, T. Ogitsu, K. Tanaka, A. Yamamoto
    KEK, Ibaraki
 
 

An intense muon beam is mandatory for the next-generation experiments to search for lepton flavor violating processes in the muon sector. The COMET experiment, J-PARC ·1021, aims to search for muon to electron conversion with an unprecedented sensitivity.. The muon beam is produced from pion decays in a strong magnetic field generated by superconducting solenoid coils. The large-bore superconducting coils enclose the pion-production target to capture pions with a large solid angle. The magnetic field is designed to have a peak of 5T at the target. To avoid severe radiation from the target, thick shielding is inserted in the warm bore of the pion capture solenoid magnet. The proton beam is injected through the gap between the pion capture solenoid and the subsequent transport solenoid magnets. For this purpose, the bore of the pion capture solenoid has to be larger than 1 m. This paper describes the design of the pion capture solenoid magnet for the COMET experiment.