LBNL, Berkeley, California
SLAC, Menlo Park, California
The scientific potential of femtosecond x-ray pulses at linac-driven FELs such as the LCLS is tremendous. Time-resolved pump-probe experiments require a measure of the relative arrival time of each x-ray pulse with respect to the experimental pump laser. In order to achieve this, precise synchronization is required between the arrival time diagnostic and the laser which are often separated by hundreds of meters. We describe an optical timing system based on stabilized fiber links which has been developed for the LCLS to provide this synchronization. Preliminary results show stability of the timing distribution at the sub-10 fsec level and overall synchronization of the x-rays and pump laser of less than 40 fsec. We present details of the implementation and LCLS and potential for future development.
LBNL, Berkeley, California
Stabilized optical fiber links have been under development for several years for high precision transmission of timing signals for remote synchronization of accelerator and laser systems. In our approach, a master clock signal is modulated on an optical carrier over a fiber link. The optical carrier is also used as the reference in a heterodyne interferometer which is used to precisely measure variations, mainly thermal, in the fiber length. The measured variations are used to correct the phase of the transmitted clock signal. We present experimental results showing sub-10 fsec relative stability of a 200 m link a sub-20 fsec stability of a 2.2 km link.
LBNL, Berkeley, California
UCB, Berkeley, California
Recent reports have identified the scientific requirements for a future soft x-ray light source and a high-repetition-rate FEL facility responsive to them is being studied at LBNL. The facility is based on a CW superconducting linear accelerator with beam supplied by a high-brightness, high-repetition-rate photocathode electron gun, and on an array of FELs to which the beam is distributed, each operating at high repetition rate and with even pulse spacing. Dependent on the experimental requirements, the individual FELs may be configured for either SASE, HGHG, EEHG, or oscillator mode of operation, and will produce high peak and average brightness x-rays with a flexible pulse format ranging from sub-femtoseconds to hundreds of femtoseconds. We are developing a design concept for a 10‐beamline, coherent, soft x‐ray FEL array powered by a 2.5 GeV superconducting accelerator operating with a 1 MHz bunch repetition rate. Electron bunches are fanned out through a spreader, distributing beams to an array of 10 independently configurable FEL beamlines with nominal bunch rates up to 100 kHz. Additionally, one beamline could be configured to operate at higher repetition rate.