A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Kim, D.E.

Paper Title Page
MOPEB014 Status of the PLS-II Magnet Design and Fabrication 307
 
  • D.E. Kim, H.S. Han, Y.-G. Jung, K.R. Kim, H.-G. Lee, S.H. Nam, K.-H. Park, H.S. Suh
    PAL, Pohang, Kyungbuk
 
 

Pohang Light Source (PLS) is planning a major upgrade of the storage ring to meet the more demanding requirement from the synchrotron light users. The main features of the major upgrade are (1) increasing the electron beam energy from 2.5 GeV to 3.0 GeV for more higher energy X-ray photons, (2) decreasing the electron beam emittance from 1.89 nm to 5.8 nm to increase the photon brilliances, and (3) increasing the number of straight sections to install the insertion devices from 10 to 20 to meet the demand for insertion devices. in the upgraded PLS (PLS-II), there will be 24 combined function dipole magnets, 96 quadrupole magnets, and 144 sextupole magnets with some auxiliary magnets for electron beam injection. In this report, the physical design features, mechanical aspects of the magnet design are described.

 
WEPEA052 Magnetic Field Measurement System for PLS-II Magnets 2603
 
  • K.-H. Park, H.S. Han, Y.-G. Jung, D.E. Kim, K.R. Kim, H.-G. Lee, H.S. Suh
    PAL, Pohang, Kyungbuk
  • B.-K. Kang
    POSTECH, Pohang, Kyungbuk
 
 

The PAL (Pohang Accelerator Laboratory) has been carrying out the performance upgrade project, PLS-II. The lattice of the storage ring for PLS-II was changed in whole. The energy was increase from 2.5GeV to 3.0GeV thus many magnets installed in storage ring at present should be replaced with new one or modified. The field of the quadrupole and sextupole magnets will be measured using the rotating coils that are newly fabricated with the engineering ceramic for the first time at PAL. The data acquisition system for the field measurement was also rebuilt to make it simple and to have a good signal to noise ratio. In this presentation, the design parameters of the ceramic rotating coil are described. And various characteristics of the field measurement system are also presented