A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Gaudreau, M.P.J.

Paper Title Page
WEPD096 Solid-State Tetrode Test Stand 3323
 
  • M.K. Kempkes, M.P.J. Gaudreau, R.A. Phillips, D. Robinson, K. Schrock
    Diversified Technologies, Inc., Bedford, Massachusetts
 
 

Diversified Technologies, Inc. (DTI) recently delivered a 500 kW CW, 33 kV solid-state test stand for the evaluation and conditioning of high power tetrodes employed in accelerator and radar systems. The test system consists of DTI-manufactured and commercially-sourced power supplies, a DTI high voltage opening switch, and DTI controls. Combining an opening switch and fast responding power supplies allows the hi-potting and high power burn-in to be consolidated in one test stand. Faulty tubes, which would not operate in a crowbar-equipped modulator, and could not be processed to health on a high potter, can be revived to health with this fast opening switch circuitry. By limiting peak fault current and follow-on-current, the total energy in an arc event is greatly minimized, reducing damage inside the tube. If greater energy (or action) is required for initial tube processing, additional load capacitance downstream of the switch can be added into the circuit for 'spot knocking' purposes. This test stand is capable of operation in pulsed mode as well as CW. This paper will address the design and construction of the test stand and discuss results since its installation.

 
WEPD097 A Klystron Power System for the ISIS Front End Test Stand 3326
 
  • M.K. Kempkes, R. Ciprian, M.P.J. Gaudreau, T.H. Hawkey, K. Schrock
    Diversified Technologies, Inc., Bedford, Massachusetts
 
 

Diversified Technologies, Inc.(DTI) has delivered a fully solid state Klystron Power Supply for the ISIS Front End Test Stand to Rutherford Appleton Laboratory in the UK. The new pulsed power supply drives a Toshiba E3740A klystron in preparation for construction of a system to demonstrate high quality intense chopped beams. DTI's system represents a significant advance in solid-state high power accelerator technology based upon a hard switch developed for the US Department of Energy (DOE) to meet similar requirements for the International Linear Collider(ILC). The system includes two 220 kW switching power supplies, a 110 kV solid state hard switch pulse modulator, mod anode and filament power supplies, klystron fault protection, and interfaces to the ISIS controls. This paper will address the design and construction of the KPS system, as well as test results from the installation at RAL in May 2009.