A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Briswalter, A.

Paper Title Page
MOPD054 Mechanical Design, Brazing and Assembly Procedures of the Linac4 RFQ 807
 
  • S.J. Mathot, P. Bourquin, A. Briswalter, Th. Callamand, J. Carosone, N. Favre, J.-M. Geisser, A.M. Lombardi, V. Maire, M. Malabaila, D. Pugnat, Ph. Richerot, B. Riffaud, C. Rossi, M.A. Timmins, A. Vacca, G. Vandoni, M. Vretenar
    CERN, Geneva
 
 

The Linac4 RFQ will accelerate the H- beam from the ion source to the energy of 3 MeV. The RFQ is composed of three sections of 1 meter each, assembled by means of ultra high vacuum flanges and an adjustable centering ring. The complete 3-m long RFQ will be supported isostatically over 3 points like a simple beam in order to minimise the maximum deflection. The ridge line, used to feed the RF power into the RFQ, will be supported via springs and its position adjusted in such way that no strain is introduced into the RFQ at the moment of its connection. The mechanical design has been done at CERN where the modules are completely manufactured, heat treated and brazed also. In that way, all of the processes are carefully controlled and the influence, notably of the heat treatments, has been understood in a better way. Since 2002 several four vanes RFQ modules have been brazed at CERN for the TRASCO and IPHI projects. A two-step brazing procedure has been tested. This technique is actually used for the assembly of the CERN Linac4 RFQ. This paper describes the design, the mechanical procedures adopted for machining and assembly and the first results obtained.