A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Berteaud, P.

Paper Title Page
WEPD007 Development of a PrFeB Cryogenic Undulator at SOLEIL 3096
 
  • C. Benabderrahmane, P. Berteaud, N. Béchu, M.-E. Couprie, J.-M. Filhol, C. Herbeaux, C.A. Kitegi, J.L. Marlats, K. Tavakoli, M. Valléau, D. Zerbib
    SOLEIL, Gif-sur-Yvette
 
 

The production of hard X rays at SOLEIL, a 2.75 GeV, requires short period and small gap in-vacuum undulators. For shifting further the radiation toward higher energies, the peak magnetic field of the undulators can be further increased by cooling the permanent magnets at cryogenic temperature below 100 K. A R&D programme for the construction of a 2 m long 18 mm period CPMU is launched: the use of PrFeB enables to increase the peak magnetic field at a cryogenic temperature of 77 K. Praseodymium was chosen instead of Neodymium type magnets, because it prevents the appearance of the Spin Reorientation Transition. The magnetic characterisation of different permanent magnet grades at cryogenic temperatures (NdFeB and PrFeB), and the magnetic and thermal measurements on a small 4 period NdFeB cryogenic undulator are presented. The status on the progress of the CPMU conception is given. The magnetic and mechanical design, including the cooling of the girders at 77K, and the thermal budget are described. The designs of the dedicated magnetic measurement benches, which will be required to check the magnetic performance of the undulator at low temperature, are also reported.

 
WEPD009 Production of High Flux Hard X-ray Photons at SOLEIL 3102
 
  • O. Marcouillé, P. Berteaud, P. Brunelle, N. Béchu, L. Chapuis, M.-E. Couprie, J.-M. Filhol, C. Herbeaux, A. Lestrade, J.L. Marlats, A. Mary, M. Massal, M.-H. Nguyen, K. Tavakoli, M. Valléau, J. Vétéran
    SOLEIL, Gif-sur-Yvette
 
 

The production of high fluxes in the hard X-rays region is a major issue on medium energy storage rings. It requires the installation of Insertion Devices with high magnetic field and a large number of periods. The construction of a superconducting wiggler has been first envisaged but reveals to be maintenance constraining, much more complex and expensive than the permanent magnet technology. A small gap in vacuum wiggler composed of 38 periods of 50 mm has been preferred. The compact magnetic system allows to produce in a limited space a magnetic field of 2.1 T in a small gap of 5.5 mm, whereas an auxiliary counterforce system based on non-magnetic springs compensate the magnetic forces (up to 8.5 Tons) acting between magnet arrays. The gap between jaws and the mechanical deformations have been controlled and corrected. Magic fingers corrections have been also performed to reduce the integrated multipoles and to minimize the 2nd order integrals resulting from the tight width of the wiggler poles. This paper presents the design of the wiggler, the construction, and the results of the measurements after magnetic corrections.